Creative Lift® Magnets
Lifting Magnets Designed for Thick, Non-Flexing steel sheets and parts.
Creative Lift permanent lift magnets are ideal for handling steel plates, die castings, forgings, etc. They eliminate the need for clamping devices, slings or chains. One person can perform operations previously calling for two or more people.
- The Original Non-Marring Roller Cam Release will easily release parts without gouging your valuable materials
- Spring return handle
- Less torque required to release load
- "Jack Screw" - Secondary Release
- Lift capacity clearly stated on magnet
- Durable Stainless Steel Casing
- Heat Resistant up to 300°F (148°C)
- RFID Chip
- 3:1 Design Factor
- ASME B30.20 BTH-1 Design Category B Service Class 3
- Made In USA (USA M.A.D.E.™)
Order Online - click the part number to add to shopping cart
|Ceramic Creative Lift® Magnets|
|Shipping||Part No.||Working Load Limit (lbs)||Ln. (in)||Wd. (in)||Ht. (in)||Magnet Ht. (in)||Magnet Wd. (in)||Magnet Ln. (in)||Weight (lbs)|
|Working Load Limit in lbs & *Maximum Sheet Length Due To Sag For Material Thickness For Single Magnet Use|
|Pull (lbs.)||3/16" (6')||1/4" (6')||3/8" (8')||1/2" (8')||3/4" (8')||1" (10')|
|Working Load Limit (WLL) Values for the creative Lift® Magnets are stated at 33% of the actual value. We recommend when lifting sheets over 8', use 2 or more lifts on a spreader bar to prevent sheet flexing, sagging or peel-off. Thin material is susceptible to magnetic bleed through, resulting in two sheets being lifted at once. Round WLL Values are based on ideal conditions. Consult the factory before specifying these magnets for use on round materials. *Max. sheet lengths are selected due to sag characteristics of specified sheet. The item to be lifted must cover the entire length and width of the magnetic poles to properly engage and release the part. CF = Consult Factory, NA = Not Applicable (Magnets will not turn "ON" with stated thicknesses.)|
|Creative Lift Spare Parts|
|Handle Return Spring||980786|
Note: Never stand under load being lifted. Always use extra caution. Only use magnetic lifts on material that does not flex or bend. The surface of the lift, and the load being lifted, need to be clean and free of chips, oil, slag, dirt, etc. Lifting magnets must be centered on load. Not recommended for painted or finish coated surfaces.